W wooster Joined Thursday October 11, 2012 Thursday January 3, 2013 #1 Hi I have two of these which I purchased recently however I notice that when I twiddle the severity adjustment knob ( or whatever you call it ) nothing seems visibly to change on the razor. Is this normal or is there something wrong with them? Thanks
Hi I have two of these which I purchased recently however I notice that when I twiddle the severity adjustment knob ( or whatever you call it ) nothing seems visibly to change on the razor. Is this normal or is there something wrong with them? Thanks
NotTheStig Joined Tuesday October 26, 2010 Location Taured Thursday January 3, 2013 #2 The base plate should lower or raise very slightly (less than a millimetre for each click) but you should be able to see it happen
The base plate should lower or raise very slightly (less than a millimetre for each click) but you should be able to see it happen
antdad Joined Friday July 10, 2009 Thursday January 3, 2013 #3 Stick a blade in it, make sure the gap on both sides is the same and consistent.
OP W wooster Joined Thursday October 11, 2012 Thursday January 3, 2013 Thread Starter #4 NotTheStig said: The base plate should lower or raise very slightly (less than a millimetre for each click) but you should be able to see it happen Click to expand... Hmm looks like I've got duff ones then :s Ah well. No use crying over spilt milk
NotTheStig said: The base plate should lower or raise very slightly (less than a millimetre for each click) but you should be able to see it happen Click to expand... Hmm looks like I've got duff ones then :s Ah well. No use crying over spilt milk
B Brianpilman Joined Tuesday May 29, 2012 Location North wales Thursday January 3, 2013 #5 Give it a good clean could be gummed up with old soap scum. Does it still click?
Tony.T Joined Thursday October 4, 2012 Location Cornwall Thursday January 3, 2013 #6 If you've got a blade in it open the 'doors' first before you try the adjuster. It won't work if the doors are locking the blade in position.
If you've got a blade in it open the 'doors' first before you try the adjuster. It won't work if the doors are locking the blade in position.