Brush handles only

Will check AliChina, I am cheap, leftover knots in question are cheap, handles are mabye cheap online, problem is finding correct sizes to fit knots...
 
_DSC8433.jpg
Was originally thinking DIY, but making a handle proved easier said than done, got a bit discouraged, might give it another go, still got Bubinga square chunks left.
 
Last edited:
Trying my luck with a handle from a chunk of bubinga again. Tools are drill plus wet&dry, no lathe so from a chunk of wood I am going for a chunk of wood with rounded corners as simple as that. Drilling a hole for knot was a pain but finally managed 30 mm wide and 15 mm deep and pretty straight without starting a fire just plenty of smoke :)
 
Last edited:
Got the knife but not the patience and elbow grease to carve in bubinga but sharpened a plane iron so square chunk is now an octagonal chunk and a bit easier to hold though a 30/32 mm knot size is not the most suitable for a squarish handle.
 
Last edited:
Back
Top Bottom