- Joined
- Monday April 11, 2011
Is it possible to do this on a blade or would a machine sander the only way to go?
Exile said:Hand sanding is the way to go at the start of your restoration career this will teach you what it takes to get a razor clean and shiny. It will also show you how to sand and what it takes to go from one grit size to the next without leaving scratches.
If you get a rubber pipe about 8 inch long by about an inch round. Cut about an inch off the end and then cut this 1 inch piece along its length use this cut end to hold the sandpaper between the 7 inch pipe and the 1 inch cut off and you will have a sanding paper holder. Use this and you won’t cut your fingers.
This isn’t my design I got this idea off Bill Ellis and I also use his jig this has saved me cutting my fingers to pieces over the years and both cost me pennies to make.
Good luck with the sanding it will take about 5 times longer than you think because the steel is hard. I use Autosol for the final finish but I’m sure the guys on here will come up with other suggestions.
stolensocks said:Thanks for your help Graham i have one more question though, do you use a demagnetizer? i have seen a few on ebay but unsure which type to buy would this be ok <!-- m --><a class="postlink" href="http://cgi.ebay.co.uk/ROLSON-MAGNETIZER-DEMAGNETIZER-MAGNTIC-TOOL-/180500296854?pt=UK_Hand_Tools_Equipment&hash=item2a06a7f496">http://cgi.ebay.co.uk/ROLSON-MAGNETIZER ... 2a06a7f496</a><!-- m -->?