- Joined
- Tuesday June 15, 2010
Just looking for a bit of help regarding one of two brushes I plan on fitting new knots into. I've taken both of the knots out of the two brushes below, I cut the bristles down and drilled the knots out.
When I drilled the knot out of the brush on the right, it turns out the handle is completely hollow inside, any suggestions about what I should fill it with, to build it up to the required height to fix the knot to? It will accept a 20mm knot.
The brush on the left will accept an 18mm knot and shouldn't be a problem as the bottom half of the handle is filled with solid material (some kind of concrete or something similar).
[attachment=0]
When I drilled the knot out of the brush on the right, it turns out the handle is completely hollow inside, any suggestions about what I should fill it with, to build it up to the required height to fix the knot to? It will accept a 20mm knot.
The brush on the left will accept an 18mm knot and shouldn't be a problem as the bottom half of the handle is filled with solid material (some kind of concrete or something similar).
[attachment=0]